|[Lighting Accessories] - [Lighting Fixtures] - [Switch]|
SD Card Programming Symphony LED flexible light strip controller | T-1000S Symphony full-color controller factory direct
Hello friends Shenzhen Shang Mingguang Power Co., Ltd. welcome your visit Thank you for your concern about our company and products;!!! Some of us do not give you good service apologize for the inconvenience, please for your understanding if we have what you need, please tell us your needs, so that we can serve you better and faster; If our products can not meet your needs or you to our products and services are not satisfied, please criticism, correction so that we can timely corrections and continue forward!
A, T-1000S System Features
1,32 level -65536 level grayscale control, software Gamma correction.
2, support a variety of point, line, surface light source, supports a variety of rules, shaped handle.
3, a single port controller output, with 2048 lights.
4, a plurality of cascade control to synchronize offline, play content stored in the SD card.
5, T-1000S store up to 16 files, multiple files sequentially copied to the SD card.
6, stored in the SD card effect should then be named: 00_1.led, 01_1.led, 02_1.led.
7, when the IC is compatible with single-lane, single-wire connection IC lamps, no need CLK clock line.
Note: When 1 T-1000S ports with load 512 lights, the playback speed of up to 30 frames / sec ports with load exceeding 512/1024 lights, with the frame rate
Increase the number of lights automatically reduced.
2. Control the frame rate of up to 32 gray IC, single port control less than 1024 when a frame rate up to 30 frames / sec. 256 gray control IC single port control less than 512 pixels at 30 frames / second.
T-1000S LedEdit2012 use must be equipped with the old version of the software does not support the version of the 2012 controller.
Second, support chips:
Third, the appearance of the picture:
Fourth, the silk screen meanings:
TTL signal (signal 245): the differential signal (485):
Note: TTL output signal for the controller must be carried out for the land and fixtures (that is, the ground controller output and lamp
With ground connected together), the use of differential signal transmission, this end of the lamp must be connected to a differential receiver.
1. T-1000S controller may use multiple cascade;
2. T-1000S is a single output port, with up to 1024/2048 points pixels;
3. When the control IC single line simply controllers DAT and DAT and GND and lamps connected to GND corresponds When the control wire to the controller IC for an DAT.CLK and GND and lamps DAT, CLK and GND should be connected to the relative.
4. When using a differential signal (485), the controller output signals A and B are connected to the corresponding signal line and lamps A (DAT +) and the signal line B (DAT-).
5. When the controller required voltage and lights as required voltage controller and the lamps can be directly connected to the same power above. When the controller and the lamp voltage is not required at the same time, the lamp and the controller can be used independently, each power supply.
6. New in effect when editing software program, select Control Model: T-1000-IC models