Pneumatic Furnace Building Machine ▏DB-type three-hammes

Pneumatic Furnace Building Machine ▏DB-type three-hammes

Product description:

The pneumatic furnace building machine is composed of compressed air distributor, cylinder liner, air hammes, length control rod and chain, mainly used for tamping, ramming or knotting of dry lining materials of IF furnace. This furnace building machine takes the design by air hammes hammering the inner wall of crucible, let the different size powders of lining materials filling the space each other, get the effect of lining materials dense. This machine also takes the design of automatic turning. It could automatic turn, and change any of the input air quantity to adjust the vibration power, assure the rammed materials even.

u Why use furnace building machine

⒈ Reduce the manpower and shorten the operation time

⒉ The crucible is even

⒊ The sintering layer of mix materials with even thickness

⒋ No harm for induction coil and furnace during working

⒌ The big volume of mix materials, keep the materials with high filling density.

⒍ Cost down

⒎ Improve the working environment

u DB-type three-hammes.

Vibration power : 1800 N

Vibration frequency: 56 Hz

Air consumption (single head) : 13 L/ S

Required air pressure: 0.6 Mpa

Application: for furnace wall furnace building operation. [8 - 60 Ton IF Induction furnace], when the crucible upper and lower diameter balance more than 280 mm

u Some reference information

⒈ About the operation time

For a 20 ton furnace, will take 6 - 7 hours to building.

For a 10 ton furnace, will take 2.5 - 3 hours to building. If by DA-Type, just need 1.5 -2 hours.

For a 5 ton furnace, will take 2 hours to building.

⒉ About the service life

Depends on the use frequency, usually the hammes are the only replaced parts. For one set of hammes, if building a 20 ton furnace every day, the service life will be 3 months.

⒊ How to select a suitable machine?

For the furnace wall vibrator, firstly according to the furnace capacity select the type, then select the suitable dimensions according to actual crucible inner diameter, for example: Ø600 ~ 840, Ø900 ~ 1140, Ø1000 ~ 1240, Ø1100 ~ 1340. If want a faster machine, DA type is prefer. If the crucible diameter balance more than 280 mm, DB type will be selected.

For the furnace bottom vibrator, select the vibration plate diameter according to the induction coil diameter.

Anyway, this machine is customized. If you have any questions, suggestions or other requirements, please advise at any time.