LED lamp | 1M Non-waterproof LED Flexible Strip ST3528N60

LED lamp | 1M Non-waterproof LED Flexible Strip ST3528N60

Product description:

The Flexible is used a very flexible PCB ribbon with high brightness SMD mounted horizontally. Three SMD LED make up one group. Each group can be cut according to the

length required. It's is sold in 5 meter for indoor use. LED strip Widely used as Home lighting, decorative ligting, Advertising lights, etc

Performance Parameter

Part No. ST3528N30 ST3528N60 ST3528N120 LED quantity 150-led 300-led 600-led Power 12W 24W 48W Dimension 5000*8*1.5mm Light source 3528 Color WW/ W/ PW/ R/ G/ B Viewing angle 120 Input Voltage DC12V Suitable controller DC12V power supply in constant voltage Standard reservation line 200mm Working temperature -10 ° C ~ 40 ° C IP rank IP20

Installation and dimensions

Installation with 3M double-sided tape to stick, the dimension chart is as follows (unit: mm)



Connection diagram


Product should meet 'use environment' requiremetn when they work.

Installation Instruction

1 . In the choice of power cord, power cord should be noted that the current carried should be larger than normal working current by the lamp brought.

2 . Controller and switching power supply must work in ventilated and dry environment.

3 . Make sure the input wire or output wire of control bus without a short circuit before operation. In the case of work such as short circuit, the internal components may be destroyed


1. Suggest led strip connection with length no more than 10meters. 3LED as a loop, the interface can be cut to use, but can not be cut in the middle of a loop

2. Collocate suitable power supply according to the total power after strip concatenation, and also pls assure the power of led adapter must be larger than the load power, or else the power supply will be burned out.

3. LED strip drove by DC12V, pls do not use output DC5V or DC24V power supply, it will not light or burn out.

4. This product is non-waterproof led series strip, suitable for indoor application, not in the rain or put into the water.

5. The soft silica gel is on the LED surface, forbid any chemical solvent smear on the surface which have chemical reaction with silicon, otherwise the leds can not light.

6. Working temperature is -10 C °~ +40 C ° .

7. If the lamp body is damaged, it must use the new alternative.

8. It can not connect power when installation or removal.