Spot pulsed wind concentrate bin filter, dust factory

Spot pulsed wind concentrate bin filter, dust factory
 

Product description:

Off-the-shelf pulsed wind concentrate bin filter. Dust factory

Bin filter Separated from the flue gas dust equipment called precipitators, or dust removal equipment. Duster can handle the amount of gas used, resistance and dust removal efficiency of the gas through a dust collector to express. Meanwhile, dust collector prices, operating and maintenance costs, longevity and ease of operations management is also considered an important factor in its performance. Use: filter is the boiler and used in industrial production facilities Duster principles is divided into the following five categories according to their function; (1) mechanical filter including gravity dust remover, inertial dust collector, centrifugal dust separator, and so on.
The second, filter cleaning method
Once every 6 months, remove the filter for cleaning.
Once every six Remove filter cleaning.
Cleaning using compressed air or high pressure steam (maximum temperature must not exceed
80 0C) ,
Use compressed air or high pressure steam cleaning
(the maximum temperature of over 80 0C) .
Outside of the filter cartridge spray wash at 40 cm distance. From the top filter slowly
Move to the bottom.
In the filter lateral distance of 40 cm for jet washing.
Gradually shift from the top of the bottom of the filter.
Cleaning after the end of the filter openings facing down so that the water flows.
After washing, opening facing down so that water will
filter out.
Placed at room temperature for about a week and allow it to dry.
Once dry place at room temperature for about a week.
Or in the oven (maximum temperature must not exceed 80 0C) baking about 20 hours
To do.
Or in the oven (the maximum temperature of over 80
0C) to try to be out of work for about 20 hours.

Three. Maintenance Maintenance
Once every 3 months, check the clean parts of the electrostatic precipitator
Is there dust appears;
If there is dust, then:
1. check that the filter element is damaged;
2. check the seal;
3. check that the filter is correctly installed on the mounting plate.
Once every three months to check
whether a dust precipitator internal
parts of the cleanliness there.
If dust :
1. Check whether the damaged filter;
2. Seal inspection sites;
3. Check whether the correct installation of
the filter installed board