960 Foam composite tile press machine may need to produce a variety of different looks roof according to the production and yield.
Tile press production shall not exceed the minimum shut height to work, that the bottom surface of the slide to the work of the surface height in the vertical minimum distance requirement 290㎜ after mold clamping, plus, plus thick crust top and bottom plate thickness of the tiles, must not exceed 290㎜, this requirement should manufacture of molds for the design, in order to avoid machine accident. always observe the height of the box and on both sides of the sliding body lubricant. pressure-watt machine is mainly composed of left and right body, the bottom link top chassis cover, composed sliding seat, hexagonal wheels, pulleys, gears, sheave mechanism, cam mechanism, lubrication pumps, hydraulic system, electric control parts, etc. equipment should be kept clean and kept clean, and not to have dirt water.
The aircraft die stamping process: by the motor through a pulley, driving the input shaft, the pinion gear, drive shaft, drive up and down movement of the sliding seat is equipped with a mold through a cam mechanism, to achieve the press shoe table turn. bit is mounted on the shaft head gear, gear transmission deadbolt, toggle wheel mounted on a hexagonal shaft sheave to achieve indexing positioned on each end of the shaft is equipped with a mounted on the same shaft pressing on with the conjugate cam back cam lever and the puck by positioning the lower mold to achieve precise positioning in the working position.