FS4-2 Skoda Bengtsson bulk density tester, Scott capacity meter, Scott capacity meter

FS4-2 Skoda Bengtsson bulk density tester, Scott capacity meter, Scott capacity meter
 

Product description:

  • Colour: -
Detailed description:
Repeatability error: 1 Samples can be measured state: FS4-2 Skoda Bengtsson bulk density tester, Scott capacity meter, Scott capacity meter
Custom processing: Measuring range: FS4-2 Skoda Bengtsson bulk density tester, Scott capacity meter, Scott capacity meter
Type: Density Tester Scope: FS4-2 Skoda Bengtsson bulk density tester, Scott capacity meter, Scott capacity meter
Dimensions: 1 (mm) Repeatability error:
Samples can be measured state: Custom processing:
Measuring range: Types of:
Scope: Dimensions:

FT-101 Scott capacity meter Bulk Density Tester: is based on the determination of GB / T 1479.2-2011 metal powder bulk density of the two parts of our company: Scott capacity meter method instead of GB GB5060-85 (metal powders - Determination of density - Part II: Scott capacity meter method) Development of powder bulk density test device at the same time meet international standards IS0 3923-2: 1981 {Determination of metal powder bulk density - Part 2: Skoda Special capacity meter method). provided in the basic structure and parameters required, the indicators are in line with standards.

sampling:

3.1 Each measured powder bulk density, should at least take 100cm 3 Sample volume, performed in triplicate.

3.2 Typically, the powder was measured according to the reception state, in some cases, the powder should be dry, but if the powder is easily oxidized, should be dried under vacuum or inert atmosphere protection. If the powder contains volatile substances, is not allowed to bake dry

FT-101 Scott capacity meter Bulk Density Tester performance indicators:

1, Upper hopper assembly: Material: 304 stainless steel; upper diameter Φ112mm, lower end diameter Φ30mm, total length: 30 + 850mm mesh: 1.18mm stainless steel mesh.

2, Cloth box: Square, built four 1 mm thick stainless steel bezel.

3, Square funnel: 60 ° square cone, the bottom diameter of 12.5mm * 12.5mm.

4, Cylindrical Cup: Material: 304 stainless steel; volume of 25 ± 0.05 ml.

5, size: 100 mm * 160 mm * 358 mm.

The test results are calculated as follows:















Than the quality and volume of the metal powder bulk density is calculated as follows:

Where: ρ as : Powder Pine Scott capacity meter method measured density, g / cm3,

m: mass of metal powder, g;

V: volume of loose powder, cm3.

Take the arithmetic average of the three measured results reported final results accurate to 0.01g / cm 3 When the difference between the results of three measurements of more than 1% of the average, the maximum and minimum values ​​should be reported with the results.

Ricoeur instrument tips, as well as associated products FT-102A vibration funnel bulk density tester, FT-100A tap density tester; FT-101 Scott capacity meter bulk density tester, FT-102 Hall flow meter / Bulk Density Tester - stainless steel ; FL4-1 Hall flow meter / powder flowability tester - brass

Note: Specific parameters, please keep in touch with us, as well as related products.