Supply of particle packing density analyzer, abrasive bulk density meter, bulk density tester

Supply of particle packing density analyzer, abrasive bulk density meter, bulk density tester
 

Product description:

Brand: Ricoeur Instrument Model: 103
Detailed description:
The scope of products: abrasive bulk density tester / particle packing density analyzer Custom processing:
Products Scope: Custom processing:











Abrasive bulk density tester / particle packing density analyzer / GB 25571 accumulation density tester / GB / T 16913 bulk density tester

FT-103 bulk density tester

FT-103 bulk density tester It is based on national standards GB / T 16913.3-1997 provisions of design and production. The device is suitable for the determination of bulk density of dust.

FT-103 bulk density tester Please refer to the sample collection GB / T 16913.1-1997 dust Physics Experiment Part 1: Dust samples collected in the relevant regulations.

FT-103 bulk density tester Principle: Dust from the funnel mouth full of free fall at a certain height measuring cup; mass per unit volume of dust inside the cup measured bulk state, that dust bulk density.

FT-103 bulk density tester Structure: funnel (flow outlet diameter 12.7mm)

Funnel made of stainless steel, which funnel taper of 60 ° ± 0.5

FT-103A activated clay bulk density measuring device

GB 25571 Bulk density tester

FT-103A activated clay bulk density measuring device Is based on national standards GB / T 25571-2010 national food safety standards, food additive provisions of activated clay design, production. The device is suitable for the determination of food additives, activated clay bulk density.

FT-103A activated clay bulk density measuring device Principle: Dust from the funnel mouth full of free fall at a certain height measuring cup; quality measured within the measuring cup bulk state unit volume, namely bulk density.

FT-103A activated clay bulk density measuring device Structure: 2.1: funnel flow outlet diameter 30mm; funnel height: 135mm, funnel made of stainless steel, 2.2: cylinder diameter: 80mm, volume: 500ml

DMP-II Type common abrasive bulk density tester

DMP-II Type common abrasive bulk density tester According to international standard ISO9136: 1989 (Determination of bulk density coarse grains) and industry standard JB / T7984.2-1999 (Ordinary coarse grit abrasive Determination of bulk density) of the relevant technical requirements of development and production of special detection equipment, suitable for detecting manufacturing bonded abrasives and coated abrasives bulk density of coarse particles of abrasive materials, but also for the detection of other granular materials Bulk density Its detection methods and results and generic detection methods internationally with full versatility.
DMP-II Type common abrasive The bulk density tester The main technical parameters
2.1 Measurement error: ≤ ± 0.02g / cm3.
2.2 measuring cylinder volume: 200 ± 0.5cm3.
2.3 Dimensions: 230mm (length) * 250mm (width) * 425mm (H)

DMP-II Type common abrasive bulk density tester

Note: Specific parameters, please keep in touch with us, as well as related products.