The company operating the FT-104 alumina bulk density tester, fluoride, Crest, quality assurance, welcome to consult the discussion.
FT-104A Alumina / Aluminum fluoride Angle of repose tester
(Alumina chemical analysis methods and determination of physical performance: Determination of repose angle) in accordance with national standards GB / T6609.24-2004 designed and manufactured for measuring the angle of repose of the powder under natural flow conditions.
1, in line YS / T581.13 alumina chemical analysis methods and determination of physical performance measured angle of repose) Technical Specification.
2, the product to meet the easy maintenance, safe, reliable, economical and practical aesthetic requirements.
3, equipment installation, commissioning and use
4, confirm the ready placement of the instrument bench is level.
5. The YS / T581.13 (alumina chemical analysis methods and determination of physical performance repose angle measurement) in the assembly diagram and technical specifications, for installation of the instrument.
Installation equipment .
1, the height of the fixed block placed on the lower discharge port, tighten the screws fixing the funnel. A guarantee 40mm height
2. Loosen the funnel bracket screw to adjust the center of the funnel with the floor to make it vertical.
3, according to the standard required to complete the test
FT-104A Alumina Angle of repose tester Meet GBT 16913-2008 dust and physical test methods GB / T 18702-2002 coal repose angle measuring method is also applicable to other products repose angle measurement, the measuring method is similar to the international phase.
Stainless steel funnel: The inner diameter of 74mm, 6mm inside diameter of the feed opening
Weight: about 16kg
Angle of repose of aluminum fluoride Measuring device
Angle of repose measuring device Mainly includes the following components:
1, stainless steel funnel: Neijing 74mm, inside through between the feed opening 6mm, two steps of aperture plate fitted with a sieve of 1mm This funnel is fastened to the bracket.
2, galvanized steel plate: material made of steel or marble, stainless steel and other corrosion-resistant base plate is made, the minimum size of: Width 200mm, length 270mm, 18mm thick plating on the polished floor of the four cross engraved on the surface 45. Angle straight. right in the center section of the funnel has a fixed height gauge positioning pin, the bottom plate below 3 adjustable horizontal feet.
3, Funnel Holder: composed of stainless steel, its structure should be perpendicular to the centerline of the fastening funnel centering pin.
4, height gauge (determine the height of the metal cylinder): It is a cylinder surface finish made of stainless steel, high 40mm, the bottom has a recess so that the center of the bottom plate with the locating pin convergence.
Ricoeur Instruments related products Recommended : FT-104A alumina / aluminum fluoride analyzer angle of repose; FT-104C aluminum fluoride (Alumina) Fluidity tester; FT-104 alumina bulk density tester