[Measuring Instrument] - [Weighing & Measuring Apparatus] - [Other Weighing & Measuring Apparatus]

Supply Ricoeur FT-105 Apparent density analyzer, apparent density measuring device, density tester

Supply Ricoeur FT-105 Apparent density analyzer, apparent density measuring device, density tester
  • Supply Ricoeur FT-105 Apparent density analyzer, apparent density measuring device, density tester
Product code: 20938100001
Unit price: 2300 CNY  (334.31 USD)
Price unit: Per piece
Minimum order:
Other info:
Visit my shop
Brand: Ricoeur Model: FT-105
Detailed description:
Whether to provide custom processing: Yes The scope of products: for funnel from the provisions set aside Determination of apparent density of plastic bulk material, measured apparent density for PVC resin
Whether to provide custom processing: Yes The scope of products: for funnel from the provisions set aside Determination of apparent density of plastic bulk material, measured apparent density for PVC resin

FT-105 Apparent density analyzer (formerly XBM-1 / XBM-2)

The instrument is mainly used to set aside provisions funnel Determination of apparent density of plastic bulk material, measured apparent density for PVC resin

The chemical industry as well as plastic profile factory quality inspection of raw materials into the plant ideal testing equipment. Products meet GB / T3402 , GB / T1636 And other standards.
Technical parameters: XBM-1 in line with GB / T1636, XBM-2 in line with GB / T3402
The main components: base, cage, funnel, flapper, by the feeder
Feeder by volume: 100m 0.5ml
Sample volume: 110ml-120ml
Funnel angle: 40 Degree, a pore size of 8mm

To meet K-6721 (1966) of the requirements

Apparent density analyzer

This method is suitable for measuring the apparent density of the powder molding compound, the mass per unit volume for molding plastic packaging, mold cavity and extrusion screw design provides parameters in line with GB / T 3402, GB 1636 standards.

Apparent density analyzer

1, Sample: extracting a sample standard product requirements.

2, the test instrument:

(1) balance: a sense of the amount of 0.1 g

(2) surface view tester

(3) The cylinder-type cup: 100 ml





3, Apparent density analyzer Test procedure:

(1) The funnel is placed on the instrument, the lower end of the small opening at the top of the measuring cylinder being 20-40 mm, and coaxial cylinder measurement possible.

(2) the striker plate into the funnel, the 100 + 5ml sample was poured into the funnel.

(3) blocking plate is pulled out quickly, the test flow freely into the measuring cylinder, the upper part of the measuring cylinder with a scraper to scrape off excess sample and on the balance of the sample cylinder weighed to the nearest 0.1 g.

(4) three times each batch tests (test sample has not re-use)

4, Apparent density analyzer test results

Mold material apparent density (D a , G / ml) is calculated as follows

m

Da=

v

Where: m- measure the quality of the cylinder in the sample (g)

v- volume measuring cylinder (100 ml)

The test results indicate the arithmetic mean of three measurements, taken two significant figures.