Thermal transfer machines, baking cup machine, flat backing machine changing cup machine equipment manufacturers

Thermal transfer machines, baking cup machine, flat backing machine changing cup machine equipment manufacturers
 

Product description:

Baking cup machine instructions'

Plugged in, turned on the power switch. (the machine rated voltage 220 v, rated input power 350 w

Sets the equipment temperature display for operating procedures: (Fahrenheit)

Initial temperature, press mode setting time, at this time, set the indicator, press the addition or subtraction key set the starting temperature.

The highest temperature: press model set for the second time, the temperature indicator, press add or subtract the highest temperature setting.

The highest temperature baking time: according to the pattern set the key a third time, at this time, a time indicator, press the addition or subtraction key set maximum temperature bake?A mortar rush huan?

Stay execution status: according to the pattern set button for the fourth time, into a state machine to perform.


Note: set the starting temperature range 200 ~ 380 degrees, to set the high temperature range 200 ~ 430 degrees.

The high temperature baking time setting range of 0 ~ 999 seconds.

The machine with the temperature setting self-locking function, that is, such as initial temperature to 340 degrees, the machine will automatically be qualified to set the high temperature range is 340 ~ 430 degrees. On the other hand, such as to set the highest temperature is 250 degrees, the machine will automatically be qualified to set the starting temperature range is 200 ~ 250 degrees.


Roast printing:
Slow roasted: the required decoration supplies good, hand down pressure, open the power switch, the temperature began to rise. When the temperature rose to the starting temperature, the buzzer singing a short press execution time, until the buzzer long syllable, press to perform again, end of hot stamping. Remove the object, the temperature will automatically return to the starting temperature gradually, baked on standby at speed.
Quick roast: in the condition of initial temperature, put a good object, hand down pressure, press execution time, until the buzzer long syllable, press to perform again, end of hot stamping. Remove the object, the temperature will automatically return to the starting temperature gradually, again at speed on standby.
4. Hot stamping design bad problem hint:
A. color slants thin: temperature?
B. design fuzzy: time is too long cause ink diffusion.
Matt: c. pattern surface pressure or temperature is too high.
D. local fuzzy pattern: hot stamping area heat distribution.
E. pattern has scar: hot stamping time is too long.
F. design colour shades: stress transfer coating uneven uneven or object.
G. sticker: the temperature is too high or bad object transfer coating.
Parameters are recommended: starting temperature set at 230 degrees, the high temperature 330 degrees, the high temperature baking time setting for 30 seconds.
Hot stamping: use clean flannelette surface of mug, will transfer paper wrapped packages mugs, paste with high temperature tape, fixed in a hot cup of tools and cavities, push pressure controller, such as the pressure is too big or too small, can adjust the push rod stroke.
Note: baking cup machine heating pad is not afraid of empty to burn, but will try to avoid the baking cup body height is far lower than the width of baking cup mat
Glass, the same don't will only a small part of the cup body into baked baking cup mat, if in a cup
A small number of design should be dealt with on the mapping of baking.






Our shop of a complete set of equipment and consumables sales
Print the cup needs the following equipment:
1, a baking cup machine
A + 2, epson printer empty even for (put ink in this)
3, the sublimation ink (put them inside the printer)
4, high temperature adhesive tape
5, cups