Polyurethane Industry structure with no silicon adhesive glue

Polyurethane Industry structure with no silicon adhesive glue
 

Product description:

Industrial glue
Product Details
Product Features
l single component; wet cured; thixotropic excellent; facade coating is not flowing; facilitate construction;
l high strength; high elasticity; strong adhesion;
l cohesion good, very resilient;
l solvent-free; be glued to the substrate without corrosion; pollution;
l After curing non-toxic, tasteless, green;
l water; oil; anti-aging; resistance to vibration fatigue;
l surface can be sanded, painted.
Product Usage
Mainly used in machinery and equipment, electronic equipment, underground mines, dies, instrumentation and other industrial bonding and sealing materials.
Technical data
project
Performance
project
Performance
project
Performance
Exterior
Black / white / gray paste
Volatile
≤4%
Sag
≤3mm
density
1.35 ± 0.05 g / cm3
hardness
30-60 Ao
Construction of the temperature
+5~+35℃
Dry time
20 ~ 60 min
Tensile Strength
≥2.0MPa
Shelf Life
9 months
Curing speed
3 ~ 5mm / d
Elongation at break
≥400 %
package
310ml aluminum cylinder, 20 / box; 300ml flexible sausage, 20 / box; 400ml flexible sausage, 20 / box; 600ml flexible sausage, 20 / box.
Storage and transportation
• Transport: Moisture, rain, sun, high temperature, away from heat, handle with care, prohibit squeeze collisions.
• Storage: Sealing and storage is at a low temperature; dry place; recommends storage at a temperature of 5 ~ 25 ℃; humidity ≤50% RH environment; prohibit stored at a temperature higher than 30 ℃ or the humidity is greater than 80% RH,
Environment.
Shelf Life
In the original packaging container, shelf life is not less than nine months, nine months later, passed the test can still be used.
Construction Technology
See related construction process different depending on the application site.
Recommendations
• It is recommended for use with the primer; for less demanding situations, being sticky substrate can be used directly by the activator after treatment;
• Selection of the product and the end of plastic; activation agent ancillary products to treat sticky substrate adhesion test must first be carried out prior to bonding; to ensure that they have good compatibility; while in use should
It should ensure that the main glue, end of plastic, activators belong qualified products shelf life.
• construction in strict accordance with the construction process, any action in violation of the construction process may cause bonding failure;
• This product is fully cured non-toxic, but before curing should avoid contact with the eyes, skin, and if skin contact with the eyes, first with soap and water or alcohol scrub, then rinse with water.
If the situation is serious, they should immediately seek medical treatment.