DS- a polyurethane mold plastic decoration environmental protection

DS- a polyurethane mold plastic decoration environmental protection
 

Product description:


DS Mold plastic decoration
Product Details
Product Features
• solvent-free; non-toxic and tasteless after curing; green;
• no corrosion of the substrate, the surface can be polished and painted;
• High strength; high flexibility; no cracking;
• Single component; wet cured; thixotropic excellent; facade construction is not flowing; simple construction;
• water; oil; Acid; do not mildew;
• puncture-resistant; anti-aging; weathering; fatigue;
• with a variety of substrates with good adhesion;
• compatibility of old glue, easy repair.
Product Usage
• between doors and walls, high-grade sanitary ware, cabinets, shower, bathtub, tile construction, home improvement glass, high-grade furniture, install the seal and all kinds of flooring adhesive.
• interior structure sealed, ground structural joints watertight seal.
Joint sealing and bonding between • interior ceiling gypsum board or between plywood.
Technical data
project
Performance
project
Performance
project
Performance
Exterior
Black / white / gray paste
Volatile
≤5%
Shear strength
/
density
1.35 ± 0.05 g / cm3
hardness
30-50Ao
Construction of the temperature
+5~+35℃
Dry time
≤90 min
Tensile Strength
≥1.6MPa
Shelf Life
9 months
Curing speed
3 ~ 5mm / d
Elongation at break
≥400 %
package
310ml aluminum cylinder, 20 / box; 400ml flexible sausage, 20 / box; 600ml flexible sausage, 20 / box.
Storage and transportation
• Transport: Moisture, rain, sun, high temperature, away from heat, handle with care, prohibit squeeze collisions.
• Storage: Sealing and storage is at a low temperature; dry place; recommends storage at a temperature of 5 ~ 25 ℃; humidity ≤50% RH environment; prohibit stored at a temperature higher than 30 ℃ or the humidity is greater than 80% RH,
Environment.
Shelf Life
In the original packaging container, shelf life is not less than nine months, nine months later, passed the test can still be used.
Construction Technology
See related construction process different depending on the application site.
Recommendations
• Selection of the product and the end of plastic; activation agent ancillary products to treat sticky substrate adhesion test must first be carried out prior to bonding; to ensure that they have good compatibility; while in use before
It should ensure that the main glue, end of plastic, activators belong qualified products shelf life.
• construction in strict accordance with the construction process, any action in violation of the construction process may cause bonding failure;
• This product is fully cured non-toxic, but before curing should avoid contact with the eyes, skin, and if skin contact with the eyes, first with soap and water or alcohol scrub, then rinse with water.
If the situation is serious, they should immediately seek medical treatment.