Plug insulating sheath abrasion tester
This device complies with IEC 60884-1 Figure 28, GB2099-2008 Figure 28, BS 1363 Fig. 9, VDE062029, AS / NZS3112 Figure 2.7, EN50075 and other standards. Test Inspection means is composed of a horizontally disposed, the center of rotation of the beam about its composition, diameter 1MM Short wire bent Two points for a U-shaped U-shaped vertically fixed on both ends of the beam . Vertical parts sticking out from under the crossbar and through the positioning beam placement for movement parallel to the axial direction of the insulating bush is worn bolt test used to detect the plug.
Working Power : AC220V / 50HZ;
Working times: 20000 ( 10000 times in each direction ) ;
. Abrasive Frequency: 15 persons 1RPM (30 beats / min) ;
Pressure load : 4-0.1 N
Working stroke : 9mm;