Shandong used stainless steel hot air circulating oven generally have heating, a circulation fan oven can be called Shandong used stainless steel hot air circulation oven, because no matter Shiyao oven structure, wind horizontal or vertical, in the final analysis are the hot air inside the loop, so all be known as Shandong used stainless steel hot air circulation oven, such as electric blast oven, the oven door temperature sterilization, etc. But in general industry term used stainless steel hot air circulating oven Shandong most oven or especially shown in the figure above, other oven From the above chart oven is evolved, such as with high-temperature sterilization requirements, air-cooled centrifugal fan into circulation fans, front and rear door, duct also made a change, it becomes a high-temperature sterilization oven door. on the map Hot air circulation shown divided into five standard models. are single door cycling, two-door two vehicles, two-door four-car, three six vehicles, eight four-door car.
Shandong used stainless steel hot air circulating oven works
Shandong used stainless steel hot air circulating oven air circulation system uses fans circulating air supply, uniform and efficient air circulation. Wind source is circulating air motor (using non-contact switch) driven by the wind wheel heater, but the hot air sent, and then through the wind Road to the oven chamber, and then use the rear air intake duct to become once again circulating air source heating use. Make sure the room temperature uniformity. As a result of the switch door action causes temperature swings occur, the air circulation system quickly restore operating status until it reaches the set temperature value
Shandong used stainless steel hot air circulation oven structure
Shandong used stainless steel hot air circulating oven consists of angle iron, stainless steel plate and cold plate.
Insulation by high density silicate cotton filling, high-density silicate cotton insulation to ensure the oven, but also to ensure the safety of users.
But the bottom of the heater installation position, the top or sides.
With a significant number of intelligent instrument to control the temperature.
Shandong used stainless steel hot air circulating oven duct design, there are two: horizontal and vertical air blowing!
Shandong used stainless steel hot air circulation oven Scope
Oven is suitable for baking chemical gas and food processing to be baked goods, curing, drying of the ink film, widely used in electronic, electrical, communications, electroplating, plastic, metal chemicals, equipment, printing, pharmaceutical , PC boards, powder, dipping, spraying, glass, wood, building materials and so on precision baking, drying, tempering, preheating, stereotypes, and processing; heat circulation, heat evenly baked items.
Shandong used stainless steel hot air circulation oven technical parameters
1, the heat source: steam, electricity, far infrared, electric steam dual-use.
2, the use of temperature: steam heating: 50-140 ℃, maximum 150 ℃ electricity, far infrared heating temperature 50-350 ℃..
3, equipped with automatic control system and computer control system.
4, common vapor pressure 0.02-0.8Mpa (0.2-8kgf / cm2).
5, equipped with electric heating by I-computing 15kw, practical 5-8kw / h.
6, special requirements indicate when ordering.
7, temperature greater than 140 ℃ or less than 60 ℃, to specify when ordering.
8, the factory car factory bake, baking tray size uniform, interchangeable.
9, baking tray size: 460 * 640 * 45