Supply ZM-11S-type hand push chiseling machine

Supply ZM-11S-type hand push chiseling machine

Product description:

Supply ZM-11S-type hand push chiseling machine

Hair cutting machines, 11 cutting hair machine, hand push chiseling machine 11, ZM-11S-type cutting hair machine, cutting hair machine, hair cutting machine prices, cutting hair machine parameters

Cutting hair machine many varieties, many types, Shandong one hundred million coal is a company specializing in the production of cutting hair machine manufacturers, are factory direct a variety of cutting hair machine, business opportunities, is to grasp the wealth Phone: Du Jingli 15376502879

First, use Introduction
ZM-11S-type hand push chiseling machine, mainly for highway bridges, airports, bridges, parking lots and other concrete floor on the ground surface of the new concrete to remove laitance of the pavement, to achieve uniform rough design. The machine is also widely used to make a variety of old ground floor before the renovation process, removing the damaged surface bumps, epoxy resin, do non-slip surface, so the new surface to fight hair, which fully reflects the value of high-efficiency low-cost applications. applies to both reservoirs, dams seepage, dangerous bridge dangerous bridge reinforcement, power plants, highways, high-speed railway, tunnel reinforcement letters and other types of buildings, and a wide range of applications.
Second, product characteristics
ZM-11S-type hand push small hair cutting machine model, you can do 24000-50600 times hammering frequency per minute. Gouge area per hour at different concrete strength up to 30-100 square meters, while reducing the damage to the foundation The machine is powered by a 3m3 / 6kg kg air compressor to operate its chisel feather high quality tungsten steel alloy produced, each pay chiseling boots head total of 11, each pay chiseling boots head life in 3000m2 above; more than five times after replacing chiseling boots head, replace a rod and piston sets, which greatly reduces the cost of using chisel feather, and without opening the body to resolve within one minute replacement boots head.
Third, the technical parameters

Product Name

Cutting hair machine





Power source

1.6m3 / 6 kg air compressor

Cutting the number of head


Gouge frequency

11 * 2200 per minute

Working width


Efficiency (C30 ~ C50 concrete grade)

Chisel deep 3-10mm, capacity 10-40 m2 per hour

Fourth, Contact: Du Jingli

Phone: 153765028790537-3151059

Fax number: 0537-2160781

Want: jnyimei0066
QQ: 2552702242
Address: Jining City, electromechanical South Road, High-tech Zone

The company also produces a variety of cutting hair machine, ZM-1A-type hand-held single-head cutting hair machine ZM-2A type handheld headed chiseling machine ZM-3A handheld three chiseling machine ZM-11S-type hand push chiseling machine ZM-23S-type hand push chiseling machine ZM-450A-type hand push chiseling machine

Shandong coal God's purpose in the customer Welcome to the new and old customer service, welcome to negotiate business !!