UPS uninterruptible power supply | B & T Bolt 12V65AH maintenance-free lead-acid battery | dedicated battery

UPS uninterruptible power supply | B & T Bolt 12V65AH maintenance-free lead-acid battery | dedicated battery
 

Product description:

Product parameters:

  • Condition: New
  • Brand: JBT / Jiabote
  • Model: 12V65AH


Product Name: JBT Carbot 12V65AH 6-GMF-65 maintenance-free lead-acid batteries Suitable for solar power generation system

This baby heavier, recommended hair logistics, the province, please consult customer service prices, thank you!

Installation and maintenance

Battery connection:

The actual capacity of the same battery or battery can be used in series;

The actual voltage of the same battery or battery can be used in series;

The connection site should be close to prevent the sparks.If the poor contact, contact surface can be cleaned with soda water;

Positive and negative shall not be reversed or short circuit;

Batteries should be separated by more than 10MM between the battery to facilitate heat.

Battery charge:

Floating charge (limit voltage, control current) Use: Charging voltage 2.275-2.30V / single cell (25 ℃);

Temperature compensation, temperature compensation coefficient per monomer 3MV / ℃ (based on 20 ℃);

Trickle to use, the battery float current adjusted to less than 2MA / AH;

Recycling (full charge that is stopped, put the finished electric charge): charging voltage 2.35-2.45V / single cell;

The maximum current shall not exceed 25% of the nominal capacity;

Note: The battery can not be used in a closed or high temperature environment, should stay away from fire.

Storage and Installation:

1, not put into use the battery should be removed cable, covered with pole-pole jacket and wipe clean;

2, once every three months to maintain the battery charge, charging method for current limiting constant voltage, the initial charge current of 0.1CA, charging voltage of 2.4V / single cell (25 ℃);

3, the battery should be stored in a dry and ventilated place, avoid direct sunlight, away from heat;

4, carrying the battery should be uniform force, the force at the battery for the shell part, to avoid damage to the pole;

5, the installation should use insulated tools to prevent clicks.

Precautions:

1, the battery charged with liquid factory, shall not attempt to disassemble the battery, to avoid danger.If you accidentally use the battery case is damaged, contact with sulfuric acid, please use a large number of water rinse, if necessary, seek medical attention immediately;

2, can not mix old and new batteries;

3, can not be sealed in the container using the battery;

4, the battery should have a complete resume, including the date of manufacture, installation date, the use of records;

5, regular (once a year) check the connection is loose, if there is loosening, should be tightened;

6, regular (once every three months) wipe the battery with a soft fabric to keep the battery clean;

7, shall not use organic solvents to clean the battery;

8, note the battery isolation, to prevent the salt bridge.