LED Car 3D Logo Laser Lights for Different Brands, Custom Logo Available

LED Car 3D Logo Laser Lights for Different Brands, Custom Logo Available
 

Product description:

More than 100 different logo options; custom logo design is acceptable; you can have your own DIY logos!!!


This LED Door Lights can be automaticlly on when car doors open.

Outpower: 3W/ 5W

Voltage: 12V/ 24V

Working Temp: -40 degrees~ 105 degrees

Material: Aluminium alloy casing

Life span: 30; 000-50; 000 hours

Certification: E4 / RDW

Installation:

This LED lights can be installed at the bottom of the door flame and make sure the Len vertical with the ground ;

1. Pull down the inside door board first. Mark the suitable location for drilling a hole.

2. Drill the hole on the door board with our borer .

3. Inset the product from the bottom of car door , then arrange the power cord.

4. Install the nut through the power cord upon the hole inside; Tighten the nut;

5. Connect the power cord according to the installation guide;

6. Adjust the lamp projection to the suitable place with wrench tool.

7. Reinstall the inside door board, then check the final effect.


.