|[Electronic and Electrical] - [Other electronic electrician]|
AC contactors CJX2-1810 (LC1-D) 220V 18A
Small two to you on the bowl 'AC contact device Daquan', Eliko secret quality and quantity.
You click blue font Slow use.
Product Buying Guide
product name : AC contactor normally open plus normally closed
product brand : Ileko
Product number : CJX2-1810 (LC1-D) 220V 380V
Scope of application : Applies to Automatic control of large current or load, remote control can be achieved in the automatic control system is widely used.
CJX2 series AC contactor is mainly used for AC 50Hz (or 60Hz), the voltage to 690V, the current to 95A circuit for remote access and segmentation circuit, frequent start and control of AC motor (hereinafter referred to as contactor) , And with the appropriate thermal relay composed of electromagnetic starter to protect the circuit may operate overload.
Meet the standards: GB 14048.4, IEC 60947-4-1. 'use'
AC contactor is the main role of high current or load for automatic control, remote control can be achieved.Contactor is a remote control, electrical equipment in the automatic control, use it to connect or disconnect the normal work of the main Circuit and control circuit, and its role and knife switch similar to its low-voltage release protection, control capacity, but also to remote control, etc., in the automatic control system is widely used.
Contactor with a small size, light weight, low power consumption, high life, safe and reliable and so on.
'Normal operating conditions and installation conditions'
1. Ambient air temperature: -5 ℃ ~ +40 ℃, within 24 hours the average does not exceed +35 ℃
2. Altitude: not more than 2000m
3. Atmospheric conditions: maximum temperature + 40 ° C, relative humidity of air not exceeding 50%, at a lower temperature can allow a higher relative humidity, for example, 90% at 20 ° C. Due to temperature changes occasionally condensate Special measures should be taken.
4. Pollution degree: 3 levels
5. Installation Category: Class II.
6. Installation conditions: installation surface and the vertical tilt of not more than ± 5 degrees
7. Shock Vibration: Product installation and use in the absence of significant shaking, shock and vibration of the place
0318 has been read